Product/Service

Heatless Dryer

Source: Henderson Engineering
The T Series Dryer features a wet air inlet at the bottom of the product, where water and oil droplets are concentrated
Request Information

The T Series Dryer features a wet air inlet at the bottom of the product, where water and oil droplets are concentrated at the bottom of the desiccant bed. During downflow depressurization and regeneration, the power of gravity helps pull the water and oil out of the dryer.

A separate chamber protects the diaphragm from the process air stream and allows replacement of the diaphragm without disrupting service or removing the valve from the dryer. Standard valve materials are cast iron body with stainless steel and brass internals.

Upflow drying design allows the dryer to operate under adverse, real-world conditions. Slugs of water or oil stay on the bottom of the bed and are easier to regenerate off. The design helps prevent desiccant fluidization.

Sahara Air Products, 95 North Main St., Sandwich, IL 60548. Tel: 815-786-9471 or 800-544-4379; Fax: 815-786-6117.