Product/Service

WEC Series Toroidal Conductivity Controllers

Source: Walchem Corporation
The new low cost CPVC sensor is perfect for applications below 180°F
  • Single or dual input: one unit monitors two baths with control output and alarm relay for each - huge savings of cost, space, installation expenses
  • Electrodeless sensor design measure accurately over a wide dynamic range and can be used in applications from 50 µS to 1000 mS
  • Use a low cost CPVC sensor for most applications, or a PEEK/316SS sensor for temperatures over 180°F.
  • Programmable for simple on/off control, or for time proportional control, which allows tight control of the conductivity using low cost pumps or valves.
  • Choice of conductivity measurement units: µS/cm, mS/cm, ppm or % concentration
  • Microprocessor based, with easy to operate menus.
  • Meets UL, CSA and CE safety and performance standards

The new low cost CPVC sensor is perfect for applications below 180°F. The WEC software has been upgraded with the addition of a Time Proportional Control Program. This provides a tight control option for your pumps or valves where ON/OFF control cannot get the job done.