Stainless Heat Exchangers

Exothermics Inc.teel heat exchangers are available in both SP and HP series and in a size and performance efficiency to match your specific application... whether an oven, dryer, or indirect heater. Our range of exchangers permits you to match the right exchanger and attain the optimum efficiency for your operation. High heat transfer effectiveness is produced by corrugating the heat transfer plates to achieve a sinusoidal wave pattern. The corrugated surface creates air flow turbulence as the air passes through the unit. Heat transfer is further enhanced by using a counterflow design. Plate sizes vary from 12", 36", 42" and 48", with unit lengths of 50", 74" and 98".

As your process air enters the unit, it's directed over the corrugated plates counterflow to the heated air. Heat from the waste air is absorbed by the plates and transferred to the cooler airstream... then exits the unit as recovered heat you can reuse or recycle.

SP Series The Standard Performance series has transfer plates spaced 1/2" apart. It combines a compact design with the structural integrity of Exothermics Inc.teel. The SP is available in two models:

• SP-VT models (Very High Temperature) models are all Exothermics Inc.teel, built to withstand air-stream temperatures up to 1200°F.
• SP-HT (High Temperature) models feature Exothermics Inc.teel built to withstand airstream temperatures up to 1000°F.

HP Series The High Performance series has transfer plates spaced 3/8" apart, providing a higher heat transfer than the SP series of the same size. The HP is available in two models:

• HP-VT (Very High Temperature) models are all Exothermics Inc.teel to withstand airstream temperatures up to 1200°F.
• HP-HT (High Temperature) models feature Exothermics Inc.teel plates to withstand airstream temperatures up to 1000°F

<%=company%>, 5040 Enterprise Blvd., Toledo, Ohio 43612 Phone: 419-729-9726 Fax: 419-729-9705